• It is used for leveling surface defects up to 30 mm with the addition of dry aggregate.
• High adhesion and surface resistance.
• Does not crack and decompose.
• High flexural and compressive strength.
• It is self leveling, creates a smooth and smooth surface. Easy to prepare and apply.

a) Surface Preparation:
The surface should be dry, clean, sound and free of dust, oil, dirt or adhesion preventive materials should be cleaned from the surface and materials such as mortar and cement residues should be scraped. Application should be done in 4m x 4m anos in order to prevent expansion and shrinkage cracks. Repair of surface defects with a depth of more than 3 cm should be done with fluid Termatect Grout repair mortars 6-8 hours before. After the surface cleaning, the surface should be primed with Termatect primer as a single layer to increase the adhesion strength and balance the surface absorbency and should be allowed to dry for 1-2 hours. In order to increase the adhesion strength before application on gross concrete surfaces, the surface should be primed with Termatect gross concrete primer as a single coat and allowed to dry for a minimum of 3 hours.

b) Product Preparation:
25 kg 8005-01/02/03 Terma Floor Self Ready Floor Leveling Screed (3-10 mm) is added slowly into approximately 5 - 5.5 liters of clean water and preferably mixed with a low speed mixer so that no lumps remain. The prepared mortar is left to mature for 2-3 minutes and mixed again for 1-2 minutes. The mixture in the container should be consumed in about 30 - 35 minutes.

c) Application Method:
After the product application is completed, it should be coated with suitable coating materials, depending on the drying time. For thicknesses between 10-30 mm, 0-4 mm aggregate should be added as 20% by weight. (About 5.0 kg for 25 kg package) 8005-01/02/03 Terma Floor Self, surface smoothing screed should be poured onto the surface applied Termatect primer and should be allowed to spread automatically. Thickness adjustment between 3-10 mm should be done with a flat trowel and ano. During the application, spiked roller or nailed shoes should be used in order to avoid air bubbles in the product and to facilitate the spreading process. The mixture should be applied to the floor within 15 minutes.