• It has not fading, dusting and cracking.
• Resistant to dirt formation.
• Thanks to its silicone additive, it is water repellent and can be used safely in wet areas.
• Resistant to mold and fungus formation.
• Provides smooth surface.
• Water and frost resistant.
• Adheres perfectly to the ceramic edges without cracking.
• Offers a rich color selection and is decorative.
• Resistant to abrasion.

a) Surface Preparation:
It should be paid attention that the ceramics are well adhered in order not to move during application, and the adhesive should be completely dry. Any dust, dirt, sawdust, construction and cement residues remaining in the joint gaps on the surfaces where the flooring process is completed should be thoroughly cleaned with a thin rod or brush. Make sure that the joint gaps are at least 2/3 of ceramic thickness. The cleaned gaps should be moistened with a wet sponge.

b) Product Preparation:
20 kg 2003 Fuga Sil joint filter (1-6 mm) is added into about 6-7 lt of clean water and mixed preferably with a low speed mixer until no lump remains. Because joint fitler added to the water is silicone additive, there may be difficulties in the mixing in the first place. Continue mixing with the mixer until a homogeneous appearance is achieved. Pay attention to the amount of water to be added to the powder mortar, avoid application in the form of grout added excess water. Excess water added to the mortar will cause cracking, easy wear and dusting. The prepared grouting material in thick consistency is left to rest for 5 -10 minutes for maturation and used after mixing for 1 -2 minutes again. The mixture in the container should be consumed within about 1 hour.

c) Application Method:
The joint sealant must be filled into the joints with a hard rubber tipped squeegee or hard rubber based joint spreading trowel. In order to fully fill the gaps, they must be pulled first parallel and then crosswise. The excess of the mortar on the surface should be peeled off with a moistened soft tip spatula, after waiting for 15-30 minutes according to the ambient temperature, wiped with a damp sponge and the thin joint layer that may remain on the surface should be cleaned thoroughly. Joint cleaning should not be started prematurely. It should not be wiped with excess wet sponge in order not to cause color fluctuation. The sponge used should be cleaned frequently. It dries on walls after 24 hours, can be walked on floors after 48 hours, can be opened to pedestrian traffic after 7 days.

• White
• Ivory
• Cream
• Beige Bahamas
• Jasmin
• Istanbul Beige
• Paper Bag
• Cappadocia Beige
• Light Pink
• Pink
• Yuruk Beige
• Brown
• Red Brown
• Dark Brown
• Pool Blue
• Atlas Blue
• Light Gray
• Gray
• Anthracite
• Black