8008 Epoksi TextureEpoxy Self Leveling, Orange Pattern
It is an epoxy resin based, two component, solvent free, in orange peel appearance (textured), thixotropic floor covering material.
► Epoxy Resin Based
► Two Component
► Textured
► Decorative
► Anti-Slip Surface
► No Solvent
> Ral
> Public Works Pos No: 04.379/H04
• It is used in multi-storey and underground car parks, storage areas, maintenance hangars, such as places exposed to moderate to heavy mechanical effects; where resistance to chemicals is required such as chemical production facilities, laboratories; in places where aesthetics, easy maintenance and cleaning are important such as shopping malls, exhibition areas, fairgrounds and in places not exposed to sunlight. Used indoors, on horizontal surfaces.
• Anti-slip feature is increased thanks to its textured surface.
• High mechanical resistance.
• High chemical resistance.
• It is liquid impermeable.
• It is aesthetic thanks to its wide color choice and bright finish.
• Long life and easy to clean.
• Solvent-free, eco friendly.
a) Surface Preparation:
The surface must be dry, clean, free of strong skate; oil, dirt or adhesion preventive materials must be removed from the surface; materials such as mortar, cement residues should be scraped. Before applying the primer on the surface, an open porous structure should be formed on the cement top layer by using surface abrasive equipment (Shotblast, Rototiger etc). Dusting should be cleaned with industrial vacuum cleaner. The abraded concrete surface should have a minimum compressive strength of 25 N/mm² and a tensile strength of 1.5 N/mm². Ensure that surface moisture, relative humidity and dew point requirements are met before application. Otherwise, the desired performance criteria cannot be reached from the product as a result of carbonation reaction on the surface. Moisture content of the surface should be maximum 4%. Relative humidity should be maximum 80%. The dew point should be above + 3°C in order to prevent condensation formation before and after the application.
b) Product Preparation:
8008 Epoksi Texture is packaged in appropriate quantities in two components. Each component is first mixed in itself. Component B (Hardener) is added to component A (Epoxy resin). It is mixed with 300 - 400 rpm mixer tip drill for 3-4 minutes until a homogenous consistency is obtained. The entire mixture is then taken to a clean container and mixed again. If part of the product is to be used, these mixing ratios should be considered. New concrete structures should be allowed to dry for a minimum of 28 days. Repair of surface defects with a depth of more than 1 cm should be done with Termatect Epoxy Repair Mortar or Termatect Grout Mortar 6-8 hours in advance. After the surface cleaning, it should be primed with Termatect Primer in single or double layers depending on the condition of the surface in order to increase the adhesion strength and balance the surface absorbency. Depending on the porosity and structure of the surface, the surface can be leveled with the addition of filler. On surfaces that are moist up to 10%, it should be applied with Termatect Primer, otherwise the application should not be done.
c) Application Method:
8008 Epoksi Texture prepared mixture should be poured onto the surface and spread with the help of a notched trowel. It should be ensured that the textured coating forms a seamless layer on the surface by crossing it perpendicular to each other with a short pile roller or coral roller. As an alternative to the above application, 0.1 - 0.5 mm quartz / silica filler should be added into 8008 Epoxy Texture to obtain a non-slip, blunted surface. Please refer to Consumption table for recommended fill amount.
“ We will continue to seek superior quality and superior service with the power we receive from you. ”
