3009-01 Elastico Plus 2KFully Elastic Waterproofing Mortar
It is cement and acrylic based, fully elastic, with cracks block, two component waterproofing material. The two components should be mixed together to provide insulation. It is resistant to positive water pressure.
► Cement and Acrylic Based
► Fully Elastic
► Two Component
► For Waterproofing Purposes
► Easy to Apply
► Low Consumption
> Grey
> Public Works Pos No:
• It is used in; Indoor and outdoor,
• Horizontal and vertical applications,
• Water tanks and swimming pools (provided that they are covered),
• Basic curtain insulation, retaining walls and basement insulation,
• Insulation of terrace roofs (provided that they are covered),
• Cisterns, irrigation channels, manholes, concrete pipes,
• Wet areas such as bathrooms, kitchens and balconies,
• Facilities such as hot springs, Turkish baths,
• Insulation of flower heads,
• Bonding ceramic, granite and coating materials.
• Easily applied on horizontal and vertical surfaces by brush, roller, trowel or spraying machine.
• Provides seamless and jointless waterproofing.
• Provides high performance water impermeability.
• It is elastic, does not shrink and does not crack.
• It is water vapor permeable and allows concrete to breathe.
• Non-toxic, ideal for drinking water tanks.
• Due to its flexibility and high adhesion, it forms an excellent insulation layer under ceramic and screed.
• Protects concrete surfaces from carbonation and chlorid.
a) Surface Preparation:
It should be ensured that the cement-based surfaces in contact with water are solid, dry, carrier, dust-free and clean and at the same time in balance. The surface should be thoroughly cleaned of any oil, grease, rust and paraffin residues that may weaken the adherence and there should be no loose particles on the surface. Iron and wooden wedges on the surface should be removed and if any, active water leakages and gaps should be filled with Termatect Sealant Mortar or Structural Repair Mortar, and corners and edges should be chamfered at least 4 cm radius. Application surface is wet and wait until the application surface is wet and dry/wet. If the coating material loses water immediately and becomes matt, it is understood that the surface is not sufficiently wetted or dries quickly. In such cases, when the air is hot or the materials remain in the wind, only 10% of component B can be added to the mixed material for the first layer.
b) Product Preparation:
Liquid component B (3009-01 Elastico Plus 2K) is poured into a clean application bucket and powder component A (3009 Elastico Plus 2K) is added slowly and they are mixed with a 400-600 rpm mixer for 3-5 minutes until a homogenous and lump-free mixture is obtained. After resting for 3-5 minutes and mixing again for 30 seconds, the material is ready for use.
c) Application Method:
Prepared 3009-01 Elastico Plus 2K mixture is applied in two or three layers with the help of a Thoro brush. The direction of brush application on each layer should be perpendicular to each other. Waiting time between coats varies according to ambient conditions.
“ We will continue to seek superior quality and superior service with the power we receive from you. ”
